The standard maximum sample opening on the brackets is 2.5mm. (* note 3 and 3.5mm also available). The wire is attached to the bracket by use of the slotted head stainless steel screws with black washers. Losen both screws then rap the wire clockwise around the screw between the washer and the bracket itself. Using the .006 wide slots on the front of the bracket place the wire in the slots then insert ring sample in bracket opening then attached to the second screw in the same way. Repeat on opposite bracket, only insert wire through ring sample.Once the vessel has been mounted, rotate clockwise to disengage the transducer safety lock. The transducer is now ready for use. Using the micrometer head located on the myograph unit rotate counterclockwise until the desired pre-load is achieved. Repeat as required during equilibration period.
